Posts: 5
Threads: 1
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Sep 2023
Reputation:
0 17-Sep-2023, 03:50 PM (This post was last modified: 17-Sep-2023, 03:58 PM by VintageFPV.) Hi All! I've just finished a build & one of the motors doesn't spin. It's showing 100% error in betaflight, and the ESC 2 doesn't show up in BL_Heli. I've tried putting the motor on a different board and it spun up fine, and I've put another motor on the board and it doesn't work either. That said, I've followed the ESC troubleshooting steps reccomended on Oscar Liang and can't actually find any shorts or anything. Is there anything else I might be missing before I undo all my soldering and just order a replacement board?
• Posts: 6,109
Threads: 172
Likes Received: 2,284 in 1,831 posts
Likes Given: 4,735
Joined: Feb 2019
Reputation:
100 there is no image attached, please share it with igmur as example.
waht fc and esc is it? did you check the esc and fc plug for a bended pin? did you try another harness between fc and esc? you cant try to unplug the signal cable of the esc/fc cable and replug a working esc with the motor signal of the nonworking one the check the fc signal.
• Posts: 407
Threads: 51
Likes Received: 152 in 108 posts
Likes Given: 264
Joined: Apr 2023
Reputation:
11 One time I had a similar problem and it was that I had the wrong dshot profile selected.
Hope it's something as easy as that
• Posts: 6,109
Threads: 172
Likes Received: 2,284 in 1,831 posts
Likes Given: 4,735
Joined: Feb 2019
Reputation:
100 i spoke about betaflight fc firmware.
the fc does the passtrough between esc and pc, if the passtrough doesnt work you cant comunicate with blheli configurator - flash the fc could solve that maybe, a communication issue
• Posts: 5
Threads: 1
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Sep 2023
Reputation:
0 No change after re-flashing BF unfortunately
• Posts: 4,073
Threads: 75
Likes Received: 2,548 in 1,858 posts
Likes Given: 3,949
Joined: May 2021
Reputation:
121 (17-Sep-2023, 06:37 PM)VintageFPV Wrote: No change after re-flashing BF unfortunately
Sounds like a dead board then.
Dangerous operations.
Disclaimer: I don’t know wtf I’m talking about.
I wish I could get the smell of burnt electronics out of my nose.
• Posts: 1,506
Threads: 49
Likes Received: 714 in 525 posts
Likes Given: 478
Joined: Oct 2020
Reputation:
93 Are you sure you have the correct firmware flashed? There are two similarly named firmwares `FLYWOOF745` and `FLYWOOF745AIO` that only differ in regards to motor pin assignments. Whichever one you have flashed now, try flashing the other one and see if it works.
•