Posts: 74
Threads: 33
Likes Received: 29 in 15 posts
Likes Given: 3
Joined: Aug 2016
Reputation:
0 anyone know if its possible to rotate quad orientation 180 degrees without swapping motor wires, i know the board command to rotate work but the motors need to be changed too.... ?
i got them soldered in that's why i wondered if i could have done it any other way...
• Posts: 61
Threads: 12
Likes Received: 5 in 5 posts
Likes Given: 2
Joined: Feb 2016
Reputation:
5 Then all you have to do is in Cleanflight put 180 in yaw and I believe in pitch and roll also. Double check it on the config page to make sure the artificial horizon moves in the correct direction when tilting the quad....
• Posts: 634
Threads: 56
Likes Received: 335 in 196 posts
Likes Given: 183
Joined: Mar 2016
Reputation:
15 18-Aug-2016, 09:31 PM (This post was last modified: 18-Aug-2016, 09:33 PM by Grisha0.) If you really have to do this, in CF/BF you can "rotate the FC" + add a custom map using mmix in cli rebinding the motors
this is theory not tested in practice. and i agree with above 10 mintues of soldering not that terrible
*edit
DragonFly beat me to it
and here a bit of learning help
All the best
Grzesiek (Grisha/ Greg)
Curently flyable: Nox 5, Minimalist 112
Bench / in progres: fixing Nox 3, Scrap
thinking about building: 450
• Posts: 2,416
Threads: 51
Likes Received: 1,861 in 1,175 posts
Likes Given: 3,315
Joined: Mar 2016
Reputation:
74 Hey sushicanfly,
Are you moving the motors to different arms, or are you just rotating the flight controller in the frame? If you are only rotating the FC, you don't need mixing or resoldering - just tell cleanflight that you've rotated the controller (yaw adjust 180).
•