Hey everyone,

i need some clarification about the battery monitoring in Cleanflight. Couldn't find any exact statement on google :/

So you have 
vbat_scale = 112
vbat_max_cell_voltage = 42
vbat_min_cell_voltage = 33
vbat_warning_cell_voltage = 35

Scale is obvious.
The max voltage is clear too.

Now my problem:
It's said that both min and warning trigger the alarm. Is is triggered differently?
What is the exact differenc for calculations, etc. between min and warning?

Can i set them to the same amount, does that make any sense?

Cheers
Diego

Hey Everyone,

I've been hesitant in getting fpv goggles for a few reasons.  I like to switch to LOS easily and I always thought that wearing FPV goggles for an extended period of time would be straining to my eyes.  I realized that my eyes were getting strained anyway after playing liftoff on my 7inch field monitor for about an hour.  Also the internal batteries on my monitor kind of suck,  I don't mind replacing them.

For those of you that use FPV goggles, do you find that they strain your eyes after a while?  Is there an optometrist we can ask about how continued use might affect your eye sight?

If they don't negatively affect your eyesight, can you guys recommend fpv goggles?  Ideally it would have hdmi input.

Thanks.

Hello All,

I have a flip32+ ,  works with baseflight, (except can not arm using sticks)
flashed to clean flight and I get no stick operation (receiver shows no signal).
I am using PWM and PPM was not selected , even tried the types of receivers, still no response.

Any ideas ?

Here's yesterday's video of us running the course we set up.  

I have a 180 frame that I would like to fit with my Naze32. But I see some PDBs out there with an onboard OSD. 
So I guess my question is should I buy a PDB separately from the OSD? If separate, which OSD and which PDB will work best with the Naze? I know theres Demon Core, OSDoge, and the Atas. Thanks

i saw this on FB and thought its brillint!

Attached Files

Thumbnail(s)
               

Do most fpv races require you to run 600mw vtx, or are there also races where they allow smaller vtx? What are your experiences?

Air mode... pls help me.
1. I need DISABLE - motor stop?
2. I need setup min throttle...? How?

Hey All,

I have one of these:


I see that there's a connector on the vtx for audio.  Does anyone know how I can wire my mic in there?  I'm guessing the red wire on the mic goes into A, but where does the black wire go?

I present to you my RedRotor Strider Flex frame.  
The build is a little over a year old and it shows some battle damage. The frame is high quality and has served me very well, and is generally well designed. but i dont fell i can be able to recommend it to anyone as the user base is small and it seems that the support from the RedRotor RC is quite low as well. 

it sits at just about 600 grams AUW with over 4 Kg of trust on 4s

 
Frame: RedRotor Strider Flex.  (modded) 
Flight Controller : Naze32 running betaflight. 
Reciver: FrSky X4R-SB (anti inverter mod) 
ESC: KISS 30 amp 
Motor: Cobra 2206 2100kv Racing edition 
Props: HQprop 6045
Battery: Nano Tech 4S 1300 mAh
FPV cam: 700 tvl plastic case
FPV Transmitter: TS5823 5.8GHz 600mw 
OSD: minimOSD