Hi Guys,
I recently saw a comment reply that you posted on your blog to a user it stated:
(you cannot use soft serial in the latest betaflight releases if you are using F1 flight controller due to resources limitation, it won’t arm if you do.)
Is this also true for Naze rev6(This is a Full Naze)? I was hoping to use the following:
X4R on SBUS connected to GND, 5V and Pin 4
X4R SmartPort connected by bridge to Pin 5-6 (SoftSerial)
Micro MinimOSD connected to UART1 TX and RX pin (I would unplug this before using USB)
I really wanted to try out the new BetaFlight firmware to use Airmode.
If this is the case can you please point me in the direction of a F3 FC that could handle all of my gear? I just purchased this Naze Rev6 for $22 so it would be a pain to know that it was a waist of money.
Or can changing firmware to Cleanflight for example make my board useful again?
Thank you for your time.
I recently saw a comment reply that you posted on your blog to a user it stated:
(you cannot use soft serial in the latest betaflight releases if you are using F1 flight controller due to resources limitation, it won’t arm if you do.)
Is this also true for Naze rev6(This is a Full Naze)? I was hoping to use the following:
X4R on SBUS connected to GND, 5V and Pin 4
X4R SmartPort connected by bridge to Pin 5-6 (SoftSerial)
Micro MinimOSD connected to UART1 TX and RX pin (I would unplug this before using USB)
I really wanted to try out the new BetaFlight firmware to use Airmode.
If this is the case can you please point me in the direction of a F3 FC that could handle all of my gear? I just purchased this Naze Rev6 for $22 so it would be a pain to know that it was a waist of money.
Or can changing firmware to Cleanflight for example make my board useful again?
Thank you for your time.