I tested my camera and vtx w/o using FC.Works great.
I have a tbs unify Pro HV and Foxxeer T-Rex and am using Hobbywing G3 stack.
The vtx will accept 2-6S and camera 4.5-16 volts.
I have wired up several air unit and Caddx vista to HW G3 stack but not analog.
Here’s a diagram and I see several ways to wire up the FPV system.Directions with vtx and cameras don’t mention using FC and I see several ways to wire up FPV system so I’m a bit confused what would give the cleanest video signal.
With tbs unify Pro HV I can power it using the 12 volt BEC or vbatt.If I use vbatt I could power camera up using 12 volt bec but vtx has a 5volt filtered supply for camera.
I don’t know whether to use vbatt and 12 volt bec for camera or just use vbatt and vtx 5volt bec on camera or should I be using a FC pad to power up camera ?
I have a tbs unify Pro HV and Foxxeer T-Rex and am using Hobbywing G3 stack.
The vtx will accept 2-6S and camera 4.5-16 volts.
I have wired up several air unit and Caddx vista to HW G3 stack but not analog.
Here’s a diagram and I see several ways to wire up the FPV system.Directions with vtx and cameras don’t mention using FC and I see several ways to wire up FPV system so I’m a bit confused what would give the cleanest video signal.
With tbs unify Pro HV I can power it using the 12 volt BEC or vbatt.If I use vbatt I could power camera up using 12 volt bec but vtx has a 5volt filtered supply for camera.
I don’t know whether to use vbatt and 12 volt bec for camera or just use vbatt and vtx 5volt bec on camera or should I be using a FC pad to power up camera ?