Hello, I can't see any image on the glasses, I can't understand the problem, I respected the diagram, the manufacturer's vtx table, even if it were in pit mode I should still see the transmission when I search, I don't know....
connected:
VTX:                                FLIGHT CONTROLLER :
DC-IN : YES (RED 10V)      10V
GND : YES (BLACK)           G
DATA : YES (BLUE)            T1
5V-0UT: NO (RED)              -
GND : NO (BLACK)              -
VIDEO : YES (YELLOW)      VO

FPV CAM:
ONLY 5V (RED)    5-36V            5V             
VIDEO (YELLOW)  VIDEO           VI
GND (BLACK)      GND               GROUND

Does the search on the goggles fix on a frequency? Do you see static, or a black screen?

I would try disconnecting the blue wire and using the FREQ button on the set the band and channel as per the manual, and then manually set the same on your goggles.

Did you select SA in the uart selection tab in betaflight?
 Does betaflight lau scripts work?
  Any OSD elements showing up?
 Camera lens cap off?
  If your vtx tables are set up correctly and you turned on SA for the uart you are using the “device ready” will say yes but Lipo must be plugged in and click save or refresh on bottom of betaflight page where vtx are shown.
   
  I like using step by step videos.There is many but here’s one.
 
 

Thanks to all for the support, I tried to test with another vtx a lower zeus and magically everything went, I'm afraid that vtx is the problem