Hello all .

My first post here .

Ive rebuild my quad from 4 inch to 5 inch.
After build was complete ive plugged in my quad with my smoke stopper all ok . Checkt all components check motor direction 3 out of 4 wrong solder the bridge on . Direction is ok now
Updated the kiss esc firmware true the kiss gui.
Armed the quad test flight ok second battery all ok
10 min koffie break . 3rd battery fly very good land the quad armed it back up one esc did not light up . After trouble shooting no solution was found. Swapped the signal wire still no response. Suddenly 2 other esc dies on me for no reason. All the esc with the bridge on died . Kiss won't respond to my mail . Can any quad expert help me.

Ps sorry for my bad English

I am not sure what you mean by "Bridge"?

(22-May-2018, 05:21 PM)voodoo614 Wrote: I am not sure what you mean by "Bridge"?

You can close a solders bridge to change the motor direction . If you visit the kiss website you can see in the instruction tap how to change the direction

I learn something today. I don't have any suggestions for your problem. Bridging jumper to reverse direction shouldn't cause your ESC to die.

What PDB are you using, sounds like an issue in the board or one bad esc fried the others.  I’m assuming you are using the kiss FC as well?

Im using a matek pdb 6s type . The fc im using is a kiss fc v1.03 ive tested the board did a continuity test all ok

(23-May-2018, 06:33 AM)Kwad.x Wrote: Im using a matek pdb 6s type . The fc im using is a kiss fc v1.03 ive tested the board did a continuity test all ok

Can you send some pics of the wiring?  We might get a better idea from there.

(23-May-2018, 12:34 PM)MarkII Wrote: Can you send some pics of the wiring?  We might get a better idea from there.

Ive removed the esc . Wireing was good no shorts . I've asked an other forum . They say its becouse of the new firmware the old esc can't handle the rapid signal the micro chip fries instantly. Flyduino keeps me on the line .

Ahh wow that’s horrible.... Keep It Simple Stupid is failing here

(24-May-2018, 12:07 AM)MarkII Wrote: Ahh wow that’s horrible.... Keep It Simple Stupid is failing here

On the rc groups forum they have a 618 pages off the kiss 24a . All ppl that have trouble with the esc .