11-May-2019, 10:39 PM
Hi guys i'm confused where to solder the signal wire from the receiver on the PDB. the board is a kakute f4v2 it has a series of pads where to solder the wires, besides the ground and the 5 volt pad i'm not sure if this wire goes to sp pad or r3 pad,the receiver is a FrSky XM+. My other question is regarding theVTX it's a TBS UNIFY PRO 5G8 V3, i'm not sure if the yellow signal wire goes to the camera or to the pad.
I would appreciate if someone could help me out on this,i don't want to ruin the pub board.
THANK YOU
I would appreciate if someone could help me out on this,i don't want to ruin the pub board.
THANK YOU