25-Jun-2024, 10:00 PM
Over the winter we had worked on getting a naked GoPro 8 setup and wired in to the FC to try and do some filming this summer. We did a quick test flight this spring to make sure everything was working as it should. Camera and quad flew as expected (only did a quick lap around the block).
A few weeks ago we went to take it out for the first flight of the summer and for some reason I couldn't get the quad to arm. After doing some trouble shooting I noticed the receiver wasn't showing any stick movement in BF. It is bound and will connect to the transmitter no problem. I thought maybe the ELRS receiver was NFG, so I swapped it out for a new ep1 but still nothing.....
I've done the usual, confirmed the correct uart, make sure its set to CRSF, I've even tried updating BF firmware just in case.
I have a micro we fly indoors, and everything works on it, so im confident its not a transmitter issue.
Could the FC be the issue? Any other suggestions on what could be the problem?
A few weeks ago we went to take it out for the first flight of the summer and for some reason I couldn't get the quad to arm. After doing some trouble shooting I noticed the receiver wasn't showing any stick movement in BF. It is bound and will connect to the transmitter no problem. I thought maybe the ELRS receiver was NFG, so I swapped it out for a new ep1 but still nothing.....
I've done the usual, confirmed the correct uart, make sure its set to CRSF, I've even tried updating BF firmware just in case.
I have a micro we fly indoors, and everything works on it, so im confident its not a transmitter issue.
Could the FC be the issue? Any other suggestions on what could be the problem?