Hey guys, so i made toothpick on GepRC Phantom frame

I got 1106 6000kV motors with 20A GHF411 AIO and Caddx EOS2 + iflight vtx 

I want to carry INSTA 360 GO2 but i want to fly indoor to film something etc. I dont really feel freestyling this crazy guy 

What do you think? Are this motors fit with 3S 550mAh on beta95x frame? Isnt kV too high? I dont really want to change motors or props because i have tons of 2.5" triblade props and 2 "reserve" motors. 

Thank you very much for your advice!

that will work, you can do a motor output limit if you doesnt touch the higher rpms or for better throttle resolution and to get low ampdraw for sure somehow good flighttimes.

personal i dont like betafpv quality, i would suggest to take a frame from a better manufacturer. geprc, diatone... or even better ronins ashigaru;
https://intofpv.com/t-roninuav-ashigaru-mk2

Hi Krysztajn,

First, that sounds like a very cool build.    

Not sure that I understand the question. Do you want to know if the quad is capable of carrying an Insta 360 Go2?  

In my opinion, your Phantom clone should easily carry an Insta 360 Go2.


        What do you think? Are this motors fit with 3S 550mAh on beta95x frame? Isnt kV too high? 

        Are you asking if the 1106 6000 KV motors will handle a 3S 550mAh battery? 

Yes, the 1106 6000KV motors should handle 3S. 6000 KV is NOT too high for 3S. 

I run GNB 3S 1100 mAh batteries on my stock GEPRC Phantom that has 1103 8000KV motors with NO problems. These GEPRC 1103 8000KV motors handle 3S just fine. I also built a Phantom "clone" and used the same GEPRC 1103 8000KV motors. Yeah, I run 3S 1100 mAh battery on that one, too. No problems. 

By the way, my stock GEPRC Phantom fitted with a GNB 3S 1100mAh battery will fly for about 16-17 minutes.

(17-Jan-2022, 11:37 PM)hugnosed_bat Wrote: that will work, you can do a motor output limit if you doesnt touch the higher rpms or for better throttle resolution and to get low ampdraw for sure somehow good flighttimes.

personal i dont like betafpv quality, i would suggest to take a frame from a better manufacturer. geprc, diatone... or even better ronins ashigaru;
https://intofpv.com/t-roninuav-ashigaru-mk2

I agree with Bat, I am not fond of BetaFPV frames. 

Personally, I like the Phantom frame for 2.5" builds. 

For 3" and 4" builds, the RoninUAV frames are my preferred choice. These frames are really nice. There is also a 2" frame, however, I have not yet done a build with that one. In fact, I am pretty much standardizing on RoninUAV frames.