Hello friends, my Tango 2 telemetry screen shows item one on the list " 01 FM: err! " when bound to the quad. All the modes seem to be working but I haven't flown it. Is this going to be an issue? Happy flying!

Have you tried deleting and then (re)discovering the sensors again? If not then try doing so.

(06-Oct-2021, 10:10 PM)SnowLeopardFPV Wrote: Have you tried deleting and then (re)discovering the sensors again? If not then try doing so.

Thank you for helping! Yeah, a few times. The 18 items get re-ordered and FM still displays " ERR* "

OK, so it seems that "!ERR" is actually a valid sensor value. The "FM" sensor is for the Flight Mode, and a value of "!ERR" for that sensor means that arming is disabled.

(06-Oct-2021, 10:47 PM)SnowLeopardFPV Wrote: OK, so it seems that "!ERR" is actually a valid sensor value. The "FM" sensor is for the Flight Mode, and a value of "!ERR" for that sensor means that arming is disabled.

Thank you Sir! Should I be able to see this sensor value on other quads?

(07-Oct-2021, 12:19 AM)Bud13420 Wrote: Should I be able to see this sensor value on other quads?

Yes, on other Crossfire equipped quads where arming is currently in a disabled state due to one or more arming flags being present (i.e. USB cable plugged in, CLI active, throttle not low etc.).

(07-Oct-2021, 07:40 AM)SnowLeopardFPV Wrote: Yes, on other Crossfire equipped quads where arming is currently in a disabled state due to one or more arming flags being present (i.e. USB cable plugged in, CLI active, throttle not low etc.).

Thank you again! Wishing you clear skies and happy flying!