You need to turn on the serial Rx on port 1 in the port tab. See if you get stick movements. If not, then turn on serial rx on port 6, but remember to turn off the serial rx on port 1 and turn off the GPS on port 6. And you need to desolder the GPS from port 6.

(01-Aug-2020, 06:31 PM)voodoo614 Wrote: You need to turn on the serial Rx on port 1 in the port tab. See if you get stick movements. If not, then turn on serial rx on port 6, but remember to turn off the serial rx on port 1 and turn off the GPS on port 6. And you need to desolder the GPS from port 6.

I tried that and I did not get any stick movements. Just to make sure I am looking in the right place the stick movement will be on the "Receiver" page right?
I already desoldered the GPS from port 6.
I am actually in the process of following this video, I did everything except solder the jumper bridge. Does this look correct to follow?

I followed the video in my previous post and also soldered the jumper. Now, I have stick movement.

None of my motors spin. Also, there is constant loud beeping once the battery is connected.

Good, you got stick movements.

No, can you spin motor in motor tab. Make sure props off. Plug in lipo. Toggle the warning message. Move the slider up. Do the motors spin.

(01-Aug-2020, 09:06 PM)voodoo614 Wrote: Good, you got stick movements.

No, can you spin motor in motor tab. Make sure props off. Plug in lipo. Toggle the warning message. Move the slider up. Do the motors spin.

No, the motors do not spin from the motor tab.

Can take picture of how you wired up your ESC to FC?

What esc do you have?

(01-Aug-2020, 09:41 PM)voodoo614 Wrote: Can take picture of how you wired up your ESC to FC?

What esc do you have?

It is just a pre-made jumper from ESC to FC.
It is a Racestar RS20A ESC

(01-Aug-2020, 10:15 PM)Skamp284 Wrote: It is just a pre-made jumper from ESC to FC.
It is a Racestar RS20A ESC

You plugged into wrong port. This is why we ask for photo even it it is a Jumper harness. 

(02-Aug-2020, 01:03 AM)voodoo614 Wrote: You plugged into wrong port. This is why we ask for photo even it it is a Jumper harness. 

That was it, thanks! The motors now spin through Betaflight and the motor numbers correspond with the diagram on Betaflight.
The motors do not spin using the Taranis though.
Also on the "Video Transmitter" page it says that my VTS is not configured or not supported. Is this something that has to be done when I get my goggles?

Have you setup an arm switch and the modes?

https://oscarliang.com/betaflight-modes/

As for your VTX, we need to find out which one you have and put in the VTX table.

(02-Aug-2020, 01:36 AM)voodoo614 Wrote: Have you setup an arm switch and the modes?

https://oscarliang.com/betaflight-modes/

No I didn't, thanks again. I will work on that now.

(02-Aug-2020, 01:37 AM)voodoo614 Wrote: As for your VTX, we need to find out which one you have and put in the VTX table.

I have a VTX03.
https://www.eachine.com/Eachine-VTX03-Su...p-697.html