Hi all,

Bought a flywoo firefly 1s analogue, plugged it into betaflight set all receiver etc and goggle view but was not getting any picyure in the goggle just text and grey screen. Quick look and apparently it was in my ports tab.....I've donr something wrong and it wont connect to betaflight. put a battery in and OSD is how I set it up reciver will bind to ELRS but I tried to flash the firmware and it still wont connect to betaflight.

What do I do please?

(20-Jun-2024, 07:36 PM)FPVrambling Wrote: Hi all,

Bought a flywoo firefly 1s analogue, plugged it into betaflight set all receiver etc and goggle view but was not getting any picyure in the goggle just text and grey screen. Quick look and apparently it was in my ports tab.....I've donr something wrong and it wont connect to betaflight. put a battery in and OSD is how I set it up reciver will bind to ELRS but I tried to flash the firmware and it still wont connect to betaflight. 

Plug in " succefully open serial port id 1" then "Serial port successfully closed"



What do I do please?

Well... It happens to me sometime, and I think this cames from the pc drivers, but, usually enough to restart the PC with the USB disconnected and connect it after the PC has finished its startup, and I suppose you already did it...
Sometimes the problem may even be the cable... the USB successfully enumerated on the PC Bus, so, the com port appears, but, as it tries to communicate it fails...
Another thing, you may have another COM on the PC, which tricks BF to assume it is the one to be used to connect the drone, and of course it fails... Chack in the device manager if the port used by BF is the correct one...

Hope this help...

Alex

(21-Jun-2024, 01:27 PM)Alex Red Wrote: Well... It happens to me sometime, and I think this cames from the pc drivers, but, usually enough to restart the PC with the USB disconnected and connect it after the PC has finished its startup,  and I suppose you already did it...
Sometimes the problem may even be the cable... the USB successfully enumerated on the PC Bus, so, the com port appears, but, as it tries to communicate it fails...
Another thing, you may have another COM on the PC, which tricks BF to assume it is the one to be used to connect the drone, and of course it fails... Chack in the device manager if the port used by BF is the correct one...

Hope this help...

Alex

HI Alex thanks for the response.

I've done the restart PC. Definitely not the USB cable as it works on another 3 drones. Drone is the only thing that is connected to the PC.
When connecting to BF it say "successfully open port ID 1 etc" then few seconds later say "port successfully closed" 
Wont open bootloader in firmware flasher. ImmpulseRC driver fixer says too many items connected. 

All I'm getting is road blocks each avenue I take.