22-Sep-2020, 03:16 PM
I finish last week my first new wing....nice but it didn't lift off.
I used 6s lion 4000 and the total weight was 1000 gr.
I crashed 4 times so I went home.....
Now I dedecided to change the motor support(only 1 cm far from the plate....it is the last photo) and reducing the weight using a 1800 lipo
6s.
Have you some suggestions to start well in this case?
Trim is good and gc is correct in the middle.
Regards and happy fly
![[Image: sL2fifDl.jpg]](https://i.imgur.com/sL2fifDl.jpg)
![[Image: 4ubPAcTl.jpg]](https://i.imgur.com/4ubPAcTl.jpg)
I used 6s lion 4000 and the total weight was 1000 gr.
I crashed 4 times so I went home.....
Now I dedecided to change the motor support(only 1 cm far from the plate....it is the last photo) and reducing the weight using a 1800 lipo
6s.
Have you some suggestions to start well in this case?
Trim is good and gc is correct in the middle.
Regards and happy fly
![[Image: sL2fifDl.jpg]](https://i.imgur.com/sL2fifDl.jpg)
![[Image: 4ubPAcTl.jpg]](https://i.imgur.com/4ubPAcTl.jpg)
![[Image: RJ5HZe1l.jpg]](https://i.imgur.com/RJ5HZe1l.jpg)