12-Aug-2022, 11:08 PM (This post was last modified: 12-Aug-2022, 11:10 PM by 4propsfine.)
As stated in the title, I have bound the goggles and controller to the vista hd of my cinelog35 Vista hd tbs crossfire 6s nano.
After binding controller to vista, the light at the left bottom of controller turns green and stops beeping.
Vista hd stops beeping.
Tested motors in betaflight and they all sin up.
Cannot get any response from controller in betaflight and the quad will not arm.
Goggles - Bound activated and firmware up to date
P1RC DJI FPV Controller - Bound activated and firmware up to date
Vista HD - Bound activated and firmware up to date
It's as if the controller is bound but will not communicate with the vista hd.
In betaflight I have changed the serial receiver selection to sbus and tried to get stick movement.
No luck.
I changed it back to serial receiver
I am not new to drones but I am a complete noob to this model and the vista with the dji fpv controller.
Has anyone else here had any experience with this and if so, please share with me the solution.
My ego is down in the dumps right now.
Thanks Guys !!
After binding controller to vista, the light at the left bottom of controller turns green and stops beeping.
Vista hd stops beeping.
Tested motors in betaflight and they all sin up.
Cannot get any response from controller in betaflight and the quad will not arm.
Goggles - Bound activated and firmware up to date
P1RC DJI FPV Controller - Bound activated and firmware up to date
Vista HD - Bound activated and firmware up to date
It's as if the controller is bound but will not communicate with the vista hd.
In betaflight I have changed the serial receiver selection to sbus and tried to get stick movement.
No luck.
I changed it back to serial receiver
I am not new to drones but I am a complete noob to this model and the vista with the dji fpv controller.
Has anyone else here had any experience with this and if so, please share with me the solution.
My ego is down in the dumps right now.
Thanks Guys !!