As stated in the title, I have bound the goggles and controller to the vista hd of my cinelog35 Vista hd tbs crossfire 6s nano.

After binding controller to vista, the light at the left bottom of controller turns green and stops beeping.
Vista hd stops beeping.

Tested motors in betaflight and they all sin up.
Cannot get any response from controller in betaflight and the quad will not arm.

Goggles - Bound activated and firmware up to date
P1RC DJI FPV Controller - Bound activated and firmware up to date
Vista HD - Bound activated and firmware up to date

It's as if the controller is bound but will not communicate with the vista hd.
In betaflight I have changed the serial receiver selection to sbus and tried to get stick movement.
No luck.
I changed it back to serial receiver

I am not new to drones but I am a complete noob to this model and the vista with the dji fpv controller.

Has anyone else here had any experience with this and if so, please share with me the solution.
My ego is down in the dumps right now.

Thanks Guys !!

If we can go back to the start:

“I have bound the goggles and controller to the vista hd of my cinelog35 Vista hd tbs crossfire 6s nano”

Did you buy a BNF quad with a Crossfire Nano RX pre-installed?

And you have a DJI radio controller?

If the answer to the above questions is yes, then:

1- You do not need the Crossfire Nano RX since this is only compatible with Crossfire Radio/TX modules.

2- Your Vista unit has not been wired up for SBUS to the FC. This is common when buying a BNF quad with a Crossfire RX.

So order of actions will be:

- Polish up your soldering skills

- Remove the Crossfire Nano RX

- Wire the Caddx Vista units SBUS pad to an inverted RX pad in the FC.

Avoid putting your drone through surgery before responding back to these questions.