29-Aug-2017, 08:25 PM (This post was last modified: 29-Aug-2017, 08:27 PM by FPVdroneshotz.)
My problem is:
I have video when I wire the foxeer right to the vtx and power the vtx from the RAM but no OSD. If I wire the Vtx to Vout and the camera to Vin, I get the OSD overlay but no video. Seems like a common problem. I've tried reflashing to an earlier version - nothing. I've tried power from vbat, from the 12v pin (I bridged the vbat and ram on the back). I've tried a Unify TBS Pro (5v) instead of the HV and bridged 5v to RAM. Same! I've tried different cameras, vtx, blah, blah, blah. I'm going nuts over here. Why can't I get video through the FC? It's clearly sending the signal because I have the OSD and I know the camera is fine because I get video when I go directly from the vtx. I have voltage everywhere you expect (checked with a multi). I guess I don't need OSD, but for a newbie, I need Battery info, etc. because my flights range so much in time. I really would like to run the OSD and GET VIDEO! :-) Any help appreciated. I've scoured the web and ran across the problem on many posts - with no solution. Most just posted they gave up.
I haven't done it yet, but would powering the camera from the Battery do any good? It seems the vin and vout is the issue. But who knows. Maybe it's a powering issue from the 5v to the camera.
Anyone have this issue or can they think of a solution I didn't try?
I have video when I wire the foxeer right to the vtx and power the vtx from the RAM but no OSD. If I wire the Vtx to Vout and the camera to Vin, I get the OSD overlay but no video. Seems like a common problem. I've tried reflashing to an earlier version - nothing. I've tried power from vbat, from the 12v pin (I bridged the vbat and ram on the back). I've tried a Unify TBS Pro (5v) instead of the HV and bridged 5v to RAM. Same! I've tried different cameras, vtx, blah, blah, blah. I'm going nuts over here. Why can't I get video through the FC? It's clearly sending the signal because I have the OSD and I know the camera is fine because I get video when I go directly from the vtx. I have voltage everywhere you expect (checked with a multi). I guess I don't need OSD, but for a newbie, I need Battery info, etc. because my flights range so much in time. I really would like to run the OSD and GET VIDEO! :-) Any help appreciated. I've scoured the web and ran across the problem on many posts - with no solution. Most just posted they gave up.
I haven't done it yet, but would powering the camera from the Battery do any good? It seems the vin and vout is the issue. But who knows. Maybe it's a powering issue from the 5v to the camera.
Anyone have this issue or can they think of a solution I didn't try?