05-Dec-2023, 02:25 PM
Good afternoon.
Just trying to get my head around everything I've read about this FC. I intend to connect receiver, cam, vtx and gps. That's the 4 uarts used up and leaves Serial_RX4 as the spare half uart on A01.
I´d like to use telemetry via S Port.
So my thinking is that I can use any of the spare motor pads, 5-8. (I fancy M7 but only because it´s address is B00 ) and create a soft serial. The same for the LED_STRIP 1 C08.
Can I convert A01 to Serial_TX4?
What about the TLM pad next to motor pad M8. Is that just ESC telemetry?
Is there a best option from these or one that I have missed?
Finally, what is PINIO 1 C09 attached to?
Thanks in advance and kind regards.
Just trying to get my head around everything I've read about this FC. I intend to connect receiver, cam, vtx and gps. That's the 4 uarts used up and leaves Serial_RX4 as the spare half uart on A01.
I´d like to use telemetry via S Port.
So my thinking is that I can use any of the spare motor pads, 5-8. (I fancy M7 but only because it´s address is B00 ) and create a soft serial. The same for the LED_STRIP 1 C08.
Can I convert A01 to Serial_TX4?
What about the TLM pad next to motor pad M8. Is that just ESC telemetry?
Is there a best option from these or one that I have missed?
Finally, what is PINIO 1 C09 attached to?
Thanks in advance and kind regards.