28-May-2020, 09:06 PM (This post was last modified: 28-May-2020, 09:07 PM by illclinton.)
FrSky XM+ receiver soldered to the SBUS per the diagram. FC is a Diatone Mamba F405 Mk2.
I have UART1 set to serial Rx, the config tab is set for serial-based Rx (SBUS) and I'm having no luck. It is bound properly, wired properly and configured properly. I ordered a new XM+ and swapped it in today and still no dice.
As far as I know this board has an inverter circuit, otherwise it wouldn't advertise SBUS. Had no issues with my old Fireworks F4 board.
Here is the wiring. It isn't pretty because I've had to remove it so many times.
Here is my Betaflight dump: https://pastebin.com/5y1NkRL6
Any ideas? I've been grounded for weeks. Last week it was a broken ESC on an AIO board.
I have UART1 set to serial Rx, the config tab is set for serial-based Rx (SBUS) and I'm having no luck. It is bound properly, wired properly and configured properly. I ordered a new XM+ and swapped it in today and still no dice.
As far as I know this board has an inverter circuit, otherwise it wouldn't advertise SBUS. Had no issues with my old Fireworks F4 board.
Here is the wiring. It isn't pretty because I've had to remove it so many times.
Here is my Betaflight dump: https://pastebin.com/5y1NkRL6
Any ideas? I've been grounded for weeks. Last week it was a broken ESC on an AIO board.