28-Sep-2016, 08:44 PM (This post was last modified: 28-Sep-2016, 08:45 PM by bombarie. Edit Reason: words )
After a flight I discovered that I was missing a screw in one of my motors (DYS SE2205 2300KV). Wouldn't be so bad if it was one of the screws attaching the motor to the frame but unfortunately it's the one keeping the motor bell attached to the stator (see picture below)
I've checked and the shaft diameter fits any M2.5 screw but I don't think it's a good idea to use just any screw. Most M2.5 screws have a head which is so broad that it would ride up against the non-rotating part of the bearings, possibly ruining it.
I've contact DYS but they aren't answering. Might anyone here know where to get these screws?
I've checked and the shaft diameter fits any M2.5 screw but I don't think it's a good idea to use just any screw. Most M2.5 screws have a head which is so broad that it would ride up against the non-rotating part of the bearings, possibly ruining it.
I've contact DYS but they aren't answering. Might anyone here know where to get these screws?