04-Apr-2020, 03:44 PM
hello ![Smile Smile](https://intofpv.com/images/smilies/smile.png)
i started to build drone, and as you already have guessed, i got a problem.
using betaflight app, Got
+ wiring done (currently into ground, 5v, and RX3 port)
+ upgraded(tried almost every version) to latest version of FURYF4OSD
+ UART3 port is open(according to RX3 but tried all, even changed wiring)
+ receiver is in serial-based mode IBUS(tried PPM but i think IA6 does not supports. there was PPM configuration, turned on but nothing have change)
- could not upgrade FLYSKY I6 firmware itself, could not buy data cable coz of covid19 limitations![Sad Sad](https://intofpv.com/images/smilies/sad.png)
could not get input into receiver tab. current channel map is AETR1234. any idea what to do?
![Smile Smile](https://intofpv.com/images/smilies/smile.png)
i started to build drone, and as you already have guessed, i got a problem.
using betaflight app, Got
- FLYSKY FS-I6 with FS-IA6 receiver
- MAMBA F405 MK2 controller
+ wiring done (currently into ground, 5v, and RX3 port)
+ upgraded(tried almost every version) to latest version of FURYF4OSD
+ UART3 port is open(according to RX3 but tried all, even changed wiring)
+ receiver is in serial-based mode IBUS(tried PPM but i think IA6 does not supports. there was PPM configuration, turned on but nothing have change)
- could not upgrade FLYSKY I6 firmware itself, could not buy data cable coz of covid19 limitations
![Sad Sad](https://intofpv.com/images/smilies/sad.png)
could not get input into receiver tab. current channel map is AETR1234. any idea what to do?