Posts: 978
Threads: 73
Likes Received: 347 in 260 posts
Likes Given: 157
Joined: Dec 2021
Reputation:
19 There are stages to a full connection.
1. Tx bound to Receiver
2. Ports set on Flight Controller page in Betaflight, etc to enable the FC to understand where the Receivers output signal is expected to appear
3. What type of signal to expect on the configuration page.
3. On the receiver page, set up that the right TX stick moves the right control bar the required amount.
• Posts: 29
Threads: 2
Likes Received: 8 in 8 posts
Likes Given: 2
Joined: Jan 2021
Reputation:
0 15-Mar-2022, 06:20 PM (This post was last modified: 15-Mar-2022, 08:23 PM by Flying Dutchman.) What BadRaven said...
On my Nazgul V2:
1 rsxr - led solid green
2 In ports tab > serial RX on UART 2
3 In config tab > Serial based + SBUS
4 self evident ;-)
But check if it's really bound first
•