After a month waiting, I received the camera.
Tested and it works. One question on the provided OSD board connection.
From the camera white is marked OSD and black as gnd. But when the plug to osd board is connected, camera OSD (white) goes to black on osd board and camera gnd (black) goes to white on osd swtich board. Is that normal? Attaching few pics.

I powered the camera from VTX vam voltage 5v, is that enough voltage for the camera?

Just pull the pin out of the connector and reorder them. But I don't think it makes any difference. I believe the camera uses resistance from the control board.

(27-Feb-2019, 12:44 AM)voodoo614 Wrote: Just pull the pin out of the connector and reorder them. But I don't think it makes any difference. I believe the camera uses resistance from the control board.

Tested and it worked without reordering them,