So I have an LHI 240 I just put together over the course of a few days. I got it all setup in betaflight and everything, but I can't seem to configure the transmitter and receiver so that it will control my drone. I can't really find the information anywhere and am really stuck here. I've tried messing around with the settings a little bit, but am very new and don't want to do anything I shouldn't do. Here's what I got for info that may help.

I have a FS T6 and an FS R6B binded with the R6B connected to channel 1 through the pins.

On my Omnibus F3 FC I have the 3 wires comming from the SBUS/PPM, 5V, and Ground.

After that, I don't really know what's wrong.

Any help is much appreciated, thanks in advanced.

The R6B is a PWM receiver. You have to connect each channel to the FC. If that is the case, you can't use this receiver with this FC.

The FS T6 and R6B are old gear. They use PWM and the R6B does not use IBUS/ppm protocols. The Omnibus F3 does not support PWM.

Not only that. The FS T6 uses the old AFHDS radio link and it only supports older AFHDS receivers.

The newer ibus/ppm receivers are AFHDS 2A only. They are not backwards compatible with older radio's.

You'll need a newer radio like the FS-i6 (AFHDS 2A) and an ibus/ppm compatible receiver like a FS-IA6B (not FS-IA6)