I have been wanting to try a five33 frame but I’m not a racer so getting a footy I could justify spending for,plus HDZero freestyle vtx will fit nicely in rear.
I’ve also been wanting to build a Umagawd Remix 2 but it’s not been available for over a year and after I got a Footy about a month ago now it’s available.
The footy is very close to a Remix 2 so flying characteristics should be the same or similar.
With a mid mount LiPo the CG should have some effects when flying or I will soon find out.
It’ll also hold a HDZero freestyle vtx,air unit or air unit lite,and it also can hold two cameras if I decide to compare analog with digital.
I’m going to try MR30 connectors for no soldering to try different motors.
Here’s a few pictures of the footy from five33 website.
It’s a very nice frame and the carbon fiber five33 uses is some of the best I’ve seen.Someone put a lot of time designing frame.It all fits together tightly and feels strong,rigid and still on the light side.
I like carbon fiber camera mounts and camera lens is well protected.
I’ll post pictures as build progresses.
I’ll be using
HDZero freestyle vtx,V2 micro camera,the included BEC and antenna.(I may use FC BEC and sma depending if I can find a F7 meeting spec requirements).
T-motor F60 or Pacers from Black Friday sales
TBS XF nano or Ghost (Depending on BF 4.3 progress)
Hobbywing 40amp 4n1 and a F7 if I can find one in stock.
Here’s where I’m at on my build.I will rewrap the wires and zip ties with tape.
I may be able to use the cap and LiPo leads as they are and run them through the GoPro mount area.
For now my 4n1 solder work is done and until I get a F7 I’m at a standstill.
I’ve also been wanting to build a Umagawd Remix 2 but it’s not been available for over a year and after I got a Footy about a month ago now it’s available.
The footy is very close to a Remix 2 so flying characteristics should be the same or similar.
With a mid mount LiPo the CG should have some effects when flying or I will soon find out.
It’ll also hold a HDZero freestyle vtx,air unit or air unit lite,and it also can hold two cameras if I decide to compare analog with digital.
I’m going to try MR30 connectors for no soldering to try different motors.
Here’s a few pictures of the footy from five33 website.
It’s a very nice frame and the carbon fiber five33 uses is some of the best I’ve seen.Someone put a lot of time designing frame.It all fits together tightly and feels strong,rigid and still on the light side.
I like carbon fiber camera mounts and camera lens is well protected.
I’ll post pictures as build progresses.
I’ll be using
HDZero freestyle vtx,V2 micro camera,the included BEC and antenna.(I may use FC BEC and sma depending if I can find a F7 meeting spec requirements).
T-motor F60 or Pacers from Black Friday sales
TBS XF nano or Ghost (Depending on BF 4.3 progress)
Hobbywing 40amp 4n1 and a F7 if I can find one in stock.
Here’s where I’m at on my build.I will rewrap the wires and zip ties with tape.
I may be able to use the cap and LiPo leads as they are and run them through the GoPro mount area.
For now my 4n1 solder work is done and until I get a F7 I’m at a standstill.