I installed a Crossfire Nano Rx in my quad and the damn thing is losing its bind to my tx16s whenever I unplug the quad.

I've followed the emergency update procedure several times and have been able to successfully rebind, but I have to start the process over each time the quad is unplugged

I'm using a Radix 2 power board and FC

Please help, I'm losing my mind ?

Thanks guys

do you have a second one to confirm it is th receiver?

(03-Dec-2022, 09:13 AM)hugnosed_bat Wrote: do you have a second one to confirm it is th receiver?

Hey man yeah I swapped it out for one I had on another quad and it worked fine

Have you used the TBS agent software to update the firmware on the receiver?   It's a pain as I think you need to update the TX to then flash the RX but not 100% sure.  I would defo look at flash the receiver with the latest firmware.   If that doesn't work most definitely a fault on the rx which is unfortunate

If you can, try a different UART. The way some of them work apparently puts some receivers into binding mode I think. I’ve read it on here a few times I’ll admit I don’t fully understand how/why, but worth a shot if you have a uart open.

Just dealt with this on 2 of my Crossfire quads - I ended up having to go through the update process through TBS Agent a couple of times before they started working again