I got a camera butter cinema frame and got the 5” and 7/8” arm combo.
It can be built as a freestyle or Deadcat orientation by turning over front arms.
It has very tight tolerances and once the bug is put into place arms aren’t moving at all.
Without nuts or standoff tight or top of sandwich plate arms do not move at all.
It’s almost a glide and has devil horned arms and is 110grams with hardware 5”,130 grams with 7/8”.
I’m going to build it as a 5” and try freestyle first then Deadcat version.
I’m going to use
inflight zing 2 2306 1750
Hobbywing F7 40amp stack
Rush Solo Tank
XF nano
Foxeer Predator V5 Micro M12 1.7mm full case
Foxeer antenna
Diantone noise isolation ground sheet
I think my favorite analog camera is Predator V5 M12 1.7mm micro full case.So far it seems to get the best focus,bright colors like a Caddx but without the unnatural colors.
I’m hoping the Rush Solo range reflects its power.I was glad to see it fit for it doesn’t fit very many frames.
The HW F7 40amp stack has to go in one way only.If the 4n1 faces forward the F7 must face forward too.Not a serious problem but I had to rotate motors and 4n1 and mount the capacitor on top of vtx.
Here’s a few pictures of the build in progress.If you look at bug fitting inside frame you can see how tight the tolerances are.No sanding or filing needed but it was a tight fit.
I had to rotate the stack and motors then move the capacitor so my next picture will be different.The capacitor didn’t hit the top plate until after I plugged in Vtx connector.Then it hit top plate and I could have forced it but I think the vibration from hitting the carbon fiber or friction could have produced noise or problems.
It can be built as a freestyle or Deadcat orientation by turning over front arms.
It has very tight tolerances and once the bug is put into place arms aren’t moving at all.
Without nuts or standoff tight or top of sandwich plate arms do not move at all.
It’s almost a glide and has devil horned arms and is 110grams with hardware 5”,130 grams with 7/8”.
I’m going to build it as a 5” and try freestyle first then Deadcat version.
I’m going to use
inflight zing 2 2306 1750
Hobbywing F7 40amp stack
Rush Solo Tank
XF nano
Foxeer Predator V5 Micro M12 1.7mm full case
Foxeer antenna
Diantone noise isolation ground sheet
I think my favorite analog camera is Predator V5 M12 1.7mm micro full case.So far it seems to get the best focus,bright colors like a Caddx but without the unnatural colors.
I’m hoping the Rush Solo range reflects its power.I was glad to see it fit for it doesn’t fit very many frames.
The HW F7 40amp stack has to go in one way only.If the 4n1 faces forward the F7 must face forward too.Not a serious problem but I had to rotate motors and 4n1 and mount the capacitor on top of vtx.
Here’s a few pictures of the build in progress.If you look at bug fitting inside frame you can see how tight the tolerances are.No sanding or filing needed but it was a tight fit.
I had to rotate the stack and motors then move the capacitor so my next picture will be different.The capacitor didn’t hit the top plate until after I plugged in Vtx connector.Then it hit top plate and I could have forced it but I think the vibration from hitting the carbon fiber or friction could have produced noise or problems.