I have a brand new controller and was programming it and have programmed in bi directional and I cannot get the the program to restart to enable me to get back to normal.  When using normal program procedures that is throttle stick full up then connect the esc, nothing happens.  If the throttle stick is centered the motor activates and does the forward and back thing. I have tried Just  above the center as the  full throttle point as the full throttle position but that just activates the motor. I have tried other methods of activation to no avail. I would hate to have to toss a brand new esc because of a program problem.

(08-Jun-2024, 06:53 AM)fritz2460 Wrote: I have a brand new controller and was programming it and have programmed in bi directional and I cannot get the the program to restart to enable me to get back to normal.  When using normal program procedures that is throttle stick full up then connect the esc, nothing happens.  If the throttle stick is centered the motor activates and does the forward and back thing. I have tried Just  above the center as the  full throttle point as the full throttle position but that just activates the motor. I have tried other methods of activation to no avail. I would hate to have to toss a brand new esc because of a program problem.

You will need to post a bit more information before you can expect anyone to give you an intelligent answer.

What ESC? What program? What transmitter? What flight controller?