Hi guys,

Could You please advice 4" frame that fits this FC:

https://flywoo.net/products/goku-hd745-e...-plus-play
(1MB FLASH) GOKU HD 745 EVO 40A AIO BL_32 DJI PLUS & PLAY MPU6000（20mm X 20mm ）

I was thinking about Lumenier QAV-S MINI 4", but sims need to remove 2 standoofs. (not good idea)
Any ideas?

Thank You

I just put one in a V2 Carnage 3.5 (cncmadness.com) with Walksnail VTX (there is a Carnage 4.0 as well) Did a build thread here. It's a nice board!

https://armattanquads.com/products/bobcat

i believe it would fit, it might not allow to use both 20x20mm mounts on the bobcat with the large aio board

.. this is one of the “frustrations” of quad building.. component fitting… you can’t go by mounting pattern, you have to have a layout of ALL components your gonna use before anything..
example: HDzero 1w vtx it shows 30x30 mounting but it’s a “chunky girl” and stuff hangs out..this too can also cause issues..A lot of manufactures are going to “plugs” on boards, minimizing breakout pads. So your wiring layout comes into play also..
It kinda sucks, getting all the components you like to include the frame, start the build and realize not everything is gonna “fit”, and now you have to make a decision… do I change the frame? Component?
I’ve been known to literally build a quad around a camera (cadxx baby ratel)..it was a PITA, but worth it..
Having a 3d printer helps, design/print “adapter” mounts at the drop of a hat doesn’t hurt either..

(23-Jan-2024, 06:01 AM)husafreak Wrote: I just put one in a V2 Carnage 3.5 (cncmadness.com) with Walksnail VTX (there is a Carnage 4.0 as well) Did a build thread here. It's a nice board!

Thanks for Your answer. I see they have 4.5" version.
I am not sure if frame is much larger. Looks almost the same..
should I try it ? hows the fiber quality ?
https://www.cncdrones.com/v2-carnage-45.html

Good carbon, would get it with the T700 option for sure! ...on whatever frame you end up deciding on.