24-Aug-2023, 12:15 AM (This post was last modified: 24-Aug-2023, 01:36 AM by QuadFlyer68.)
Do any FC AIO/ESC manufacturers give you the correct parameters to plug into BetaFlight for accurate ADC voltage and current measurement?
Brand new BetaFlight AIO flight controller had 100 for current scale and -500 for offset. After some flights I see this is 4X higher than it should be.
Betaflight defaults for current scale and offset are 400 and 0, respectively.
Doing some test flights, recording mAh from OSD, re-charging (fast, not balancing), recording mAh put back in, and trying BF default values and calculated values to get closer to reality.
Is it really that hard for manufacturers to do a little calibration and provide some ballpark numbers ?
Brand new BetaFlight AIO flight controller had 100 for current scale and -500 for offset. After some flights I see this is 4X higher than it should be.
Betaflight defaults for current scale and offset are 400 and 0, respectively.
Doing some test flights, recording mAh from OSD, re-charging (fast, not balancing), recording mAh put back in, and trying BF default values and calculated values to get closer to reality.
Is it really that hard for manufacturers to do a little calibration and provide some ballpark numbers ?
_____________________________________
Walksnail / Avatar … It’s better than analog !
Walksnail / Avatar … It’s better than analog !