31-May-2017, 12:16 AM
I had a working quad, then unfortunately flashed my Naze32 V6 Acro Board with Cleanflight 2.0. I then experienced the following.
1. Motors would not arm (not beeping) when battery or USB from computer is connected to FC.
2. Receiver tab in Cleanflight showed input from Transmitter. (indicating tx is bound to rx)
3. Motors would not spin on input from tx.
4. Motors would not respond in Cleanflight Motor mode.
5. Flashing orange light on Naze board.
I then re-flashed the original version of Cleanflight , that was on my Naze prior to flashing 2.0, onto the board. I experienced the following.
1. Motors armed (beeping confirmed)
2. Motors would not spin with input from tx.
3. Flashing orange light on Naze board
Thinking the FC may be fried, I replaced it with a Naze 32 V Full Board.
I flashed the board with the latest version of Cleanflight 1.9 not wanting to use 2.0. I am experiencing the following.
1. Motors arm. (make expected beeping)
2. Motors not spinning up with input from tx.
Any one have any ideas to solve the the current problem?
I cannot connect to Cleanflight as 2.0 will not operate with 1.9.
I have a Chromebook which automatically updated the Cleanflight app to 2.0 and does not support downloading the 1.9 version.
Thank you for any assistance.
1. Motors would not arm (not beeping) when battery or USB from computer is connected to FC.
2. Receiver tab in Cleanflight showed input from Transmitter. (indicating tx is bound to rx)
3. Motors would not spin on input from tx.
4. Motors would not respond in Cleanflight Motor mode.
5. Flashing orange light on Naze board.
I then re-flashed the original version of Cleanflight , that was on my Naze prior to flashing 2.0, onto the board. I experienced the following.
1. Motors armed (beeping confirmed)
2. Motors would not spin with input from tx.
3. Flashing orange light on Naze board
Thinking the FC may be fried, I replaced it with a Naze 32 V Full Board.
I flashed the board with the latest version of Cleanflight 1.9 not wanting to use 2.0. I am experiencing the following.
1. Motors arm. (make expected beeping)
2. Motors not spinning up with input from tx.
Any one have any ideas to solve the the current problem?
I cannot connect to Cleanflight as 2.0 will not operate with 1.9.
I have a Chromebook which automatically updated the Cleanflight app to 2.0 and does not support downloading the 1.9 version.
Thank you for any assistance.