Guys, colleagues, friends. Share a normal guide on slicers for the Klipper. Cura is great for marlin. But there are problems with the code for Klipper. Prusa is good, but my weak mind cannot comprehend all its magnificence. What to do?

If you don’t have ad block on your browser:
https://all3dp.com/2/cura-klipper-tutorial/

otherwise:
https://www.obico.io/blog/cura-with-klipper-firmware/



Don't feel bad, I don't run Klipper atm...

8^/

I became very good friends with Orca. Ender 3 V3 SE also turned out to be a very good machine for personal use. But with Klipper. In the stock version it is also very good, but with Klipper it is much better.
https://pblvsky.gitbook.io/ender3v3se/re...ol/klipper

(02-Jan-2024, 08:48 PM)lyoha Wrote: Guys, colleagues, friends. Share a normal guide on slicers for the Klipper. Cura is great for marlin. But there are problems with the code for Klipper. Prusa is good, but my weak mind cannot comprehend all its magnificence. What to do?

I don't have a guide to point you to, but I may be able to help out if you're using SuperSlicer. Its a fork from Prusa I believe and its the only one I've been able to dial in with klipper. And now that I think about it, you could use the Prusa slicer as well as the settings are very similar, but I still managed better prints with Superslicer.

Orca has made great friends with Klipper. This is also a Prusa fork, but the interface is clearer to me than the original Prusa. Well, a couple of months of experiments on setting up the printer and printing settings also yielded results. And I already want Voron 2.4.