hello,
so my cousin recently broke one of my switches on the back of my Turnigy evolution, and I cannot boot up the receiver, because it displays a message to put all the switches in their up position and lower the throttle. I tried nudging the remains of the switch in the right position but was unsuccessful, I also tried disconnecting it but the issue remained. What can I do now?



hope the image works.

Obviously its best to get a replacement switch in the long run.

A switch can be set up as NO (normally open) or NC (normally closed). If you unplug the switch and the radio complains about the switch then it’s probably NC.

I'm not sure which switch that is but here are some:

https://hobbyking.com/en_us/catalogsearc.../?q=switch

(26-Sep-2021, 01:34 PM)kafie1980 Wrote: Obviously its best to get a replacement switch in the long run.

A switch can be set up as NO (normally open) or NC (normally closed). If you unplug the switch and the radio complains about the switch then it’s probably NC.

so can I change this or do I have to just buy another one, as MrSolo suggested?
thanks for the help

---

(26-Sep-2021, 04:04 PM)MrSolo Wrote: I'm not sure which switch that is but here are some:

https://hobbyking.com/en_us/catalogsearc.../?q=switch

thanks for the link

I can’t remember Flysky firmware anymore but I think it had the ability to disable switch warnings like OpenTX does.

If not you could probably exit the warning and disable that switch or assign that channel to another switch.