1500.  IMO, 1200 is too low.  I have  1720's on my 7 inch and if I were to do it again, I think I would go just a smidgen lower.

(13-Feb-2019, 12:25 AM)sirdude Wrote: 1500.  IMO, 1200 is too low.  I have  1720's on my 7 inch and if I were to do it again, I think I would go just a smidgen lower.

Thanks Chris, I was concerned that 1200 was too low.....I will make it 1500 then!

FINALLY, all the parts are in for this build.  And as life would have it, I have other projects that will take precedent over starting the build.  But at least I have everything.  I had to order the VTX and MMCX cable from TBS as everyone else was backordered.  TBS takes F O R E V E R!  Not as bad as Banggood, but almost.

Pretty happy with everything.  I'm a little disappointed in the Brother Hobby motors.  They just don't look as nice as T-motor.  Hopefully they hold up well.  Rotors are an unknown.  Many of the 7 inch rotors are failing, primarily HQs.  MAS make good rotors, but they may be jello prone when stressed.  Reports are, cruising with them should be fine.  Getting rotors I like may be a work in progress.  Super excited to fly with the Falkor FPV cam.

Below is the build list.

Nice setup.
Do you know what is the size of this frame (motor to motor)?
I have some other options and couldn't find the exact size of this frame.
Thanks.