04-Apr-2020, 03:44 PM
hello
i started to build drone, and as you already have guessed, i got a problem.
using betaflight app, Got
+ wiring done (currently into ground, 5v, and RX3 port)
+ upgraded(tried almost every version) to latest version of FURYF4OSD
+ UART3 port is open(according to RX3 but tried all, even changed wiring)
+ receiver is in serial-based mode IBUS(tried PPM but i think IA6 does not supports. there was PPM configuration, turned on but nothing have change)
- could not upgrade FLYSKY I6 firmware itself, could not buy data cable coz of covid19 limitations
could not get input into receiver tab. current channel map is AETR1234. any idea what to do?
i started to build drone, and as you already have guessed, i got a problem.
using betaflight app, Got
- FLYSKY FS-I6 with FS-IA6 receiver
- MAMBA F405 MK2 controller
+ wiring done (currently into ground, 5v, and RX3 port)
+ upgraded(tried almost every version) to latest version of FURYF4OSD
+ UART3 port is open(according to RX3 but tried all, even changed wiring)
+ receiver is in serial-based mode IBUS(tried PPM but i think IA6 does not supports. there was PPM configuration, turned on but nothing have change)
- could not upgrade FLYSKY I6 firmware itself, could not buy data cable coz of covid19 limitations
could not get input into receiver tab. current channel map is AETR1234. any idea what to do?