Put some 2023 triblades on the 1102 motors (well half anyways) and they do seem better for this setup. Much grippier but also more prop wash so needs some tuning. Also flew the 1002 right after. Despite having analog video and a scratched up lens, I think I had more fun with the lighter setup and was flying a little more aggressively. A little looser and slides in fast turns, but not too bad. Flew a 300mah pack but flight time was very short, under 3 minutes, although temps were near freezing and its an old pack.
Not sure this comparison would be meaningful to anyone else, but just the two flights side by side.

Recently discovered that the M1.4x3 screws that are included with all of these whoop size motors are ever so slightly too short for the Bassline frame. They will hold the motors down, but one impact will rip the lower threads off and dislodge the motor. Going to order some M1.4x5 screws instead and replace all of them. Been ripping it up good though! Enough fun to sit in nearly freezing weather and not care!