Everything was fine until I kind of landed hard on my back patio. i assume a connection just came loose but I'm a noob and not sure where to start looking. I guess I could just take her apart and see what I find, any help would be appreciated, it's a walkera f210 if that helps.

Looks like the VTX module on that has a connector that just plugs onto another board (flight controller?). I suggest at the very least you take the VTX module out and re-seat it. In the worst case you may need to replace it. While it's out, check for any cracked or dry solder joints on the module board.

The video below will help show you how to get it out.

BTW, what happened to your other post about crashing into the power lines and one of your motors not working, and your receiver not binding? Did you manage to sort that out and if so, what was the problem?

(11-Sep-2018, 11:20 PM)SnowLeopardFPV Wrote: BTW, what happened to your other post about crashing into the power lines and one of your motors not working, and your receiver not binding? Did you manage to sort that out and if so, what was the problem?

Yea I got all that figured out, the motor had some dirt/rocks between the motor and motor guard. So after I cleaned it out good it turns fine. I'm not sure what was up with my osd but when I got home it was fine, and as far as the binding goes I'm ashamed to admit but that was just me panicking thinking i really messed it up and wasnt arming the quad lol.

And thanks I'll take her apart and see what's going on. that's probably a good time to clean it up, it's starting to look like the underside of my lawn mower.

Well I guess the module took s crap on me. All the solder joints look good and I cleaned it up with some alcohol just incase but still nothing.