Posts: 16
Threads: 2
Likes Received: 3 in 3 posts
Likes Given: 3
Joined: Jun 2016
Reputation:
0 Lately when my naze32 rev6 is powers on the buzzer gives off 3 fast beeps and 2 slow beeps. Here is my video.
Has anyone seen this before?
While it is beeping like this I can't connect to it via betaflight.
Does it with either battery or USB power
I have the accelerometer off
• Posts: 1,290
Threads: 67
Likes Received: 713 in 473 posts
Likes Given: 1,216
Joined: Mar 2016
Reputation:
23 I have two quads the use the same board. Mine acts the same way when it powers up but with but the beeps are probably three times as long with longer intervals in-between. On mine, the three consecutive beeps are the gyros calibrating. Not sure what is going on with yours...error code maybe?
"Damn the torpedoes!!! Full speed ahead!!!"
• Posts: 1,070
Threads: 70
Likes Received: 742 in 378 posts
Likes Given: 577
Joined: Jan 2016
Reputation:
44 Sounds like an error code most probably associated with a dead gyro/gyro not found. I had the same on my rev5 I got from multirotorparts and they confirmed it's a hardware issue and sent me a new one. I was able to flash sometimes, but not connect to gui.
You can try a solder reflow on gyro chip if you want to save this board, I've read it sometimes solves the issue. I just trashed mine.
• Posts: 634
Threads: 56
Likes Received: 335 in 196 posts
Likes Given: 183
Joined: Mar 2016
Reputation:
15 or you can reuse it as part of an intro to darude sandstorm
question - was it flying before or it is a fresh build? if fresh have you connected the board before soldering stuff on it?
All the best
Grzesiek (Grisha/ Greg)
Curently flyable: Nox 5, Minimalist 112
Bench / in progres: fixing Nox 3, Scrap
thinking about building: 450
• Posts: 16
Threads: 2
Likes Received: 3 in 3 posts
Likes Given: 3
Joined: Jun 2016
Reputation:
0 It is not a fresh build. The beeping eventually stops and it reboots and everything is fine. I feel like the gyro may be going bad. Just going to bite the bullet and buy a Motolabs Cyclone.
• Posts: 634
Threads: 56
Likes Received: 335 in 196 posts
Likes Given: 183
Joined: Mar 2016
Reputation:
15 in that case i would order new board and replace it... as this will eventually fail in the crucial moment (electronics is known to break in the worst possible moment)
as you describe it looks lie gyro is starting starting starting... eventually kicks in... question when will it stop ?
All the best
Grzesiek (Grisha/ Greg)
Curently flyable: Nox 5, Minimalist 112
Bench / in progres: fixing Nox 3, Scrap
thinking about building: 450
•