12-Aug-2016, 11:35 PM
Hello all,
I have naze32 rev5 board and FrSky XSR receiver. I am using CPPM and thus the UART2 port is free on my board.
I connected S.Port to RC3 pin on naze (UART2 TX pin).
After quite a lot of tries, I am still not able to make the telemetry running.
My question are:
It is possible to make the telemetry running on UART2 port? (Or shall I use SoftSerial?)
Is it necessary to short RC3 and RC4 pins? (Why is there RX necessary?)
Is it necessary to place between RC3 and RC4 diode or resistor? (I read that sometimes it helps.)
If someone make it running, could you please give here the picture with connection and with a setting used in BetaFlight / CleanFlight?
I have naze32 rev5 board and FrSky XSR receiver. I am using CPPM and thus the UART2 port is free on my board.
I connected S.Port to RC3 pin on naze (UART2 TX pin).
After quite a lot of tries, I am still not able to make the telemetry running.
My question are:
It is possible to make the telemetry running on UART2 port? (Or shall I use SoftSerial?)
Is it necessary to short RC3 and RC4 pins? (Why is there RX necessary?)
Is it necessary to place between RC3 and RC4 diode or resistor? (I read that sometimes it helps.)
If someone make it running, could you please give here the picture with connection and with a setting used in BetaFlight / CleanFlight?