I have bought a ar wing and going to fpv it, just maybe bite off more than I can chew! ?
As am new to this am looking at following a diagram to understand were everything goes should be ok with soldering in the rx, beeper and GPS just need some advise on were to solder esc, servo?
Have a friend who helps but really need to start to learn myself.
Kit I have is
Matek f405 std
RunCam swift 2
Beitian BN 220
Crossfire Nano rx
And the standard esc think its 30amp, servo and motor you get with the sonic ar mini.
Thanks in advance ?

The best way to learn is to draw up a wiring diagram yourself and then post it back here for comment. We can then tell you if it's correct, and if not we can tell you what you need to change.

You mentioned that something was attached to your first post but I don't see anything. See the following post for how to upload pictures...

https://intofpv.com/t-how-to-upload-pictures

Hi.
Did you look on the Matek page. Looks like the wiring in the INAV Wiring tab is what you are looking for.
Flight Controller F405-STD, Standard – Matek Systems
You will also need a Power distribution Board like the Matek PDB-XT60  with 5V and 12 volt outputs.
PDB-XT60 w/ BEC 5V & 12V – Matek Systems

This makes it realty simple. Or you can get a flight controller that does it all in one board like the Matek F722-PX
Flight Controller F722-PX – Matek Systems
The Matek page shows all the wiring for Wing.

I could be wrong. As I am quite new at this myself.
Please jump on in this post if I am not correct..

Regards Hargard.