I’ve setup camera control using OSD pin on an HGLRC F7 and Matek F7 FCs. I just got a Mamba F722S and it says camera control is available and in BF it is mapped to pin B08. But there is no pad labeled camera control and their [limited] documentation makes no reference to that pad.

Has anyone successfully setup camera control on Mamba F7 FC using OSD pin? I can always buy a new camera that has the tx/rx vs OSD/GND but I have a new camera (RC swift 2) that I would like to use and avoid having to buy a new camera.

Thanks in advance!

Jeff

Just because the resource was assigned in BF, that does not mean there is a breakout pad. If you don't see it, then you will just have to remap an used pin like PPM for camera control.

(18-Apr-2020, 01:34 AM)voodoo614 Wrote: Just because the resource was assigned in BF, that does not mean there is a breakout pad. If you don't see it, then you will just have to remap an used pin like PPM for camera control.

Ok. That makes sense. I have a inquiry into their support. If I don’t hear back I will remap the resource.

Thanks
Jeff

(18-Apr-2020, 02:26 AM)jforhan Wrote: Ok. That makes sense. I have a inquiry into their support. If I don’t hear back I will remap the resource.

Thanks
Jeff

Hey there, did they ever respond?