Hello,

Yesterday I was flying my second lipo and after 4 minutes of flight my video in my DJI goggle v2 stopped with the message "Image transmission stopped". Fortunately, for me, I was only at 3 meters of the ground and at 10 meters of me. So i check my drone and i see that the led of the caddx vista was red. First i reboot my goggle but the caddx vista led stay red and still no image. Then i disconnect and reconnect the lipo and then the led of the caddx vista get green. And the image came back in the goggle.
I continue to fly after that and nothing happen. But know i'm afraid that happen again.
And my drone was working well, since 4 mouths until yesterday.

Do you know what happen? is it a bug of the caddx vista? If it was a connection issue, the caddx vista will get back to green without reboot, right?

I don't know what to do

Thank you for your help.

Check the cable from the Vista to the camera - I've had the same thing happen, and it always ended up being the cable came slightly loose - Once plugged back in, and sealed with a little hot glue, and no issues since

(05-Feb-2023, 07:29 PM)relentlesstech Wrote: Check the cable from the Vista to the camera - I've had the same thing happen, and it always ended up being the cable came slightly loose - Once plugged back in, and sealed with a little hot glue, and no issues since

Thanks, i check the cable but it seams ok. When it appens to you the led of the caddx vista was red also ?

(08-Feb-2023, 09:03 AM)Snyfir Wrote: When it appens to you the led of the caddx vista was red also ?

Sometimes the LED was red, and other times the green and red were lit, just very dim - In all cases the cam cable was the cause (I do have one Vista that stopped working mid-flight, with the red led, but have not been able to find out why it won't work - I re-soldered connections, and changed cables several times, still not working) - I would also carefully check the pins on both ends of the cable, if one pin gets damaged in any way the Vista will stop working.

Even if the coaxial cable between the Vista and the camera "looks" OK from the outside it might not be internally, or it might have become partially unseated from one of the connectors.

1. Re-seat the coaxial cable connectors at both ends by unplugging and re-plugging them very carefully so as not to risk damaging the connectors or the sockets.
   
2. If (1) doesn't work then replace the coaxial cable with a new one.