Hello everybody, I need help figuring out how to wire my flight controller - I want to use an IFlight F7 Mini with an DJI O3 and a TBS nano as far as I see it both of the parts are using the same input or am I wrong ? can someone please help me figure out how to wire it correctly
21-Aug-2023, 10:56 AM (This post was last modified: 21-Aug-2023, 10:58 AM by hugnosed_bat.)
i dont use dji but i believe uart2 would only be used if you use the dji rclink?
you have plenty of uarts on an f7 board, you could use the ones i marked in green and the 5v and gnd pads next to it, it does require soldering but you might have a heated solder iron for the nanorx anyway.
Yeah soldering is not the problem - I was worrying if I would have to use the exact port for the crossfire nano. But apparently that's not the case they just thought it would be easier to show it that way. Ok thank you a lot!