18-Aug-2017, 09:36 PM
(18-Aug-2017, 09:21 PM)jamesw Wrote: No soldering required. Just unscrew the back case, unscrew the gimbals, unplug the wires, and then reverse that process.
Calibration is done via on-screen prompts after install and takes 10 seconds.
The M7s also come self-centering so you'll have to unlock one of them, and the procedure is different than the regular gimbals, but in both cases it's simply tightening/loosening a screw on the gimbal.
Just read some posts on the new M9 R gimbals. I`m thinking you would only need to order one. (throttle) Is that correct?