if your FC doesn't power on with USB cable, but works with the 5V pins on motor pins... what could be damaged?
Responses from MI Group:
Could be the diodes on the top left of this schematic, If it isn't the connector? its almost always the bat54c diodes.
Possibly the usb welds came loose? If you have a heat gun see if reflowing the welds works. Depending on the fc the usb can be a weak point.
I had the same thing but the other way around.. Just tossed it and installed a new one
Could it be the USB cable?
Responses from MI Group:
Could be the diodes on the top left of this schematic, If it isn't the connector? its almost always the bat54c diodes.
Possibly the usb welds came loose? If you have a heat gun see if reflowing the welds works. Depending on the fc the usb can be a weak point.
I had the same thing but the other way around.. Just tossed it and installed a new one
Could it be the USB cable?