After a crash which caused my capacitor to break off(attached to FC) my finder beeper LED is flashing and the beeper is making strange noise when I arm the motors. I had replaced the cap with a 220u 35v before I tried flying it again. At first I thought my props were hitting something, but when I pulled off my goggles and hovered I could tell it was the finder. It also had interference in the video feed when I was flying. One time I landed the beeper would not stop buzzing. Thinking the cap was the cause I pulled it off, but the beeper still made noise. I then swapped out the finder with an extra but it had the same symptoms.
This is a Flywoo Explorer LR4. Afraid that if I keep flying it something will fail at the worst possible time.
Update:
Looking at the flight controller it is missing one of the pins the connects to the ESC. Going to attempt soldering a jumper between the boards. If the smoke is released I guess it will be time for an upgrade.
Update 2:
Jumper did not make any change.
Thanks,
Ed
This is a Flywoo Explorer LR4. Afraid that if I keep flying it something will fail at the worst possible time.
Update:
Looking at the flight controller it is missing one of the pins the connects to the ESC. Going to attempt soldering a jumper between the boards. If the smoke is released I guess it will be time for an upgrade.
Update 2:
Jumper did not make any change.
Thanks,
Ed