Hello again! I need a little help from your awesome team again.

On short, I want to display my OSD from BF in my DJI Goggles v2. I watched a couple of tutorials and did everything right. Activated OSD in BF, checked all I wanted to show in goggles, turned ON Custom OSD from Display menu in Goggles and still nothing. I own an iFlight Protek 35 HD that came with a TBS Nano Rx receiver and a Radiomaster TX16S. I just activated all of them, upgraded all the firmwares, I did a test flight today with all 6 batteries and since the motors stopped on my first after about 3-4 min (without a gopro) without any warning and without being able to see the battery remaining voltage or usage, I cannot shoot properly on a very important project I have in a few days.

Any ideas?

Run the following commands in the CLI which will activate the MSP data connection on UART1. Then the Caddx Vista will be able to read the Betaflight OSD data from the FC...

Problem solved! I'm going to post this here because other people may get a "ready to fly" drone without an instruction manual and with the wrong information.

Firstly: SnowLeopard was kind enough to remember that in my particular setup, the receiver was soldered to UART3 port, not UART2 as it said on the sticker and in the "mini foldable pamflet" I got as an instruction manual. Enough said that after I enabled the right port, all was well.

Secondly: For my problem above, I had to enable MSP on UART1 in Ports menu in Betaflight so my Configuration would show on goggles. I remember I saw a tiny picture in that pamflet in which the MSP for UART1 was checked, along with the wrong Serial for UART2 and I tried it and it worked.

Note to self and other FPV begginers out there: take the time and learn this stuff one information at a time. Do this when you're well rested, especially if you want to build everything yourself! I had to learn everything in about a week and I had to troubleshoot so many things I couldn't find online... Took me about 20-30 hours and a couple of very late nights, since I am in a rush to film a short film with this baby on this Saturday...

Conclusion: Hats down to the fpv community and all you guys out there that are here for us newbies.

Cheers! Have a nice week, everyone!

(03-Oct-2021, 10:12 PM)SnowLeopardFPV Wrote: Run the following commands in the CLI which will activate the MSP data connection on UART1. Then the Caddx Vista will be able to read the Betaflight OSD data from the FC...

Code:

serial 0 1 115200 57600 0 115200
save

Dude, this forum is amazing ) you literally replied to me faster with the exact solution, than I could write that thank you message and the fact that I managed to solve this.

Keep up the awesome work!