Posts: 94
Threads: 19
Likes Received: 0 in 0 posts
Likes Given: 2
Joined: Aug 2021
Reputation:
0 Hi,
After a small crash my camera on the flywoo 1s stopped working.
All the connections seems ok and solid on, the picture is black but the stats are coming up on my goggles.
anything i can check or sounds like i need to replace the camera?
thanks,
Hanan
• Posts: 954
Threads: 71
Likes Received: 340 in 254 posts
Likes Given: 157
Joined: Dec 2021
Reputation:
19 09-May-2022, 05:48 PM (This post was last modified: 09-May-2022, 05:50 PM by BadRaven.) Means the Flight Controller is OK as far as OSD. Is the antenna on the camera or remote? Are you SURE the wiring is OK.? How many wires from camera to FC baord, three or four? Wires might have been tugged and broken inside the sleeving.
• Posts: 42
Threads: 8
Likes Received: 6 in 6 posts
Likes Given: 45
Joined: Jan 2022
Reputation:
0 Check to make sure that the camera wires did not come off under that black silicone glue. To me it sounds like a problem with the camera or camera wiring.
• Posts: 94
Threads: 19
Likes Received: 0 in 0 posts
Likes Given: 2
Joined: Aug 2021
Reputation:
0 ok what is a good camera replacement?
preferably from banggood....thanks!
• Posts: 4,550
Threads: 38
Likes Received: 1,245 in 1,064 posts
Likes Given: 430
Joined: Aug 2020
Reputation:
118 I only have experience with the Caddx Ant and Runcam Nano 3. Both are good cameras but the Runcam Nano 3 has very low latency but lower resolution picture compared to the Caddx Ant which has higher resolution but I feel the additional latency.
• Posts: 4,550
Threads: 38
Likes Received: 1,245 in 1,064 posts
Likes Given: 430
Joined: Aug 2020
Reputation:
118 Seems to be similar in size but the way the camera is mounted on the Flywoo Firefly 1S quads is but press fitting the camera lens into the 3d printed canopy.
You will need to measure the diameter of the original camera that came with the quad to be sure else you will need to modify the canopy or design and print a new one.
• Posts: 94
Threads: 19
Likes Received: 0 in 0 posts
Likes Given: 2
Joined: Aug 2021
Reputation:
0 Okay.... Please bare with me... I'm getting there very slowly so I got this camera.
Do I cut the connector and solder black, Yellow red?
• Posts: 4,550
Threads: 38
Likes Received: 1,245 in 1,064 posts
Likes Given: 430
Joined: Aug 2020
Reputation:
118 09-Jul-2022, 12:48 AM (This post was last modified: 09-Jul-2022, 12:49 AM by kafie1980.) I am unable to see any attachment.
If the FC only has solder pads then you will need to cut off the connector and solder red (5v), black (gnd) and yellow (video) to the FC.
•