Hi,

After a small crash my camera on the flywoo 1s stopped working.

All the connections seems ok and solid on, the picture is black but the stats are coming up on my goggles.
anything i can check or sounds like i need to replace the camera?
thanks,
Hanan

Means the Flight Controller is OK as far as OSD. Is the antenna on the camera or remote? Are you SURE the wiring is OK.? How many wires from camera to FC baord, three or four? Wires might have been tugged and broken inside the sleeving.

Check to make sure that the camera wires did not come off under that black silicone glue. To me it sounds like a problem with the camera or camera wiring.

ok what is a good camera replacement?
preferably from banggood....thanks!

I only have experience with the Caddx Ant and Runcam Nano 3. Both are good cameras but the Runcam Nano 3 has very low latency but lower resolution picture compared to the Caddx Ant which has higher resolution but I feel the additional latency.

https://www.banggood.com/Caddx-Ant-Lite-...mds=search

will this one work?

Seems to be similar in size but the way the camera is mounted on the Flywoo Firefly 1S quads is but press fitting the camera lens into the 3d printed canopy.

You will need to measure the diameter of the original camera that came with the quad to be sure else you will need to modify the canopy or design and print a new one.

Okay.... Please bare with me... I'm getting there very slowly so I got this camera.

Do I cut the connector and solder black, Yellow red?

Attached

I am unable to see any attachment.

If the FC only has solder pads then you will need to cut off the connector and solder red (5v), black (gnd) and yellow (video) to the FC.