Hello everyone.
I have ordered parts for my first build.
A lovely little 3s Tadpole.
I think I have the wiring done, but I have one issue.
The Mamba F411 AIO 25A only have 2 uart ports, one for the rc and one I'll use for the VTX.
I'd love to be able to control the runcam split 4 from the transmitter as well.
![[Image: OId8s4wl.jpg]](https://i.imgur.com/OId8s4wl.jpg)
Any ideas how to handle this?
The wiring diagram from diatone is only for DJI, so I'm a bit lost.
I'm think about doing soft serial, and maybe use RX2 and LED for tx/rx, but I'm up for ideas how to best do this.
Best regards, and thank you in advance.
I have ordered parts for my first build.
A lovely little 3s Tadpole.
I think I have the wiring done, but I have one issue.
The Mamba F411 AIO 25A only have 2 uart ports, one for the rc and one I'll use for the VTX.
I'd love to be able to control the runcam split 4 from the transmitter as well.
![[Image: OId8s4wl.jpg]](https://i.imgur.com/OId8s4wl.jpg)
Any ideas how to handle this?
The wiring diagram from diatone is only for DJI, so I'm a bit lost.
I'm think about doing soft serial, and maybe use RX2 and LED for tx/rx, but I'm up for ideas how to best do this.
Best regards, and thank you in advance.